1958 ORDINANCES - Laserfiche WebLink

Home Browse Search

(6) GRADES OF ALL PROPOSED STREETS. (7) ALL PARCELS OF LAND INTENDED TO BE DEDICATED OR RESERVED FOR PUBLIC USE OR TO BE RESERVED IN THE DEED FOR THE COMMON USE OF PROPERTY OWNERS IN THE SUBDIVISION. (8) AREAS SHOWN IN THE COMPREHENSIVE CITY PLAN AS PROPOSED SITES FOR SCHOOLS, PARKS OR OTHER PUBLIC USES WHICH ARE LOCATED IN WHOLE OR IN PART WITHIN THE LAND BEING SUBDIVIDED. (9) PRELIMINARY SKETCH PLANS INDICATING THE PROPOSED METHOD OF ACCOMPLISHING DRAINAGE, WATER SUPPLY AND SEWAGE DISPOSAL. APPROVAL OF SUCH PRELIMINARY PLANS DOES NOT CONSTITUTE APPROVAL OF FINAL UTILITY PLANS REQUIRED AS A PART OF THE FINAL PLAT. (10) PRELIMINARY CROSS SECTIONS, PROFILES AND ROAD GRADES. (11) THE LOCATION OF EXISTING ZONING DISTRICT LINES AND THE PROPOSED USE OF THE PROPERTY BEING SUBDIVIDED. (12) DATE, NORTH POINT AND SCALE. SECTION 35-6. FINAL PLATS. A SUBDIVIDER SHALL FILE THE ORIGINAL LINEN TRACING AND FOUR (4) PRINTS THEREOF OF THE FINAL PLAT PREPARED BY A SURVEYOR OR CIVIL ENGINEER LICENSED BY THE STATE AND SUPPORTING DATA LISTED HEREIN, WITH THE OFFICE OF THE PLANNING COMMISSION AT LEAST SEVEN (7) DAYS PRIOR TO THE MEETING AT WHICH THE PLAT IS TO BE CONSIDERED. THE PLAT SHALL BE DRAWN AT A SCALE OF TWO HUNDRED (200) FEET TO THE INCH UNLESS OTHERWISE APPROVED BY THE PLANNING COMMISSION. THE MAXIMUM SHEET SIZE SHALL BE SEVEN AND THREE QUARTERS (7 3/4") BY SEVENTEEN (17) INCHES. A. FINAL PLAT SHALL SHOW. (1) THE TITLE UNDER WHICH THE SUBDIVISION IS TO BE RECORDED AND THE NAME OR NUMBER OF THE SECTION OF A PART OF A LARGER TRACT. (2) A STATEMENT THAT THE SUBDIVISION OF THE LAND DESCRIBED HEREIN IS WITH THE FREE CONSENT OF THE UNDERSIGNED OWNERS, PROPRIETORS AND TRUSTEES. (3) THE BOUNDARY LINES OF THE AREA BEING SUBDIVIDED WITH ACCURATE DISTANCES AND BEARINGS. THE BOUNDARIES SHALL BE DETERMINED BY AN ACCURATE FIELD SURVEY. (4) THE EXACT LAYOUT IN GENERAL CONFORMITY WITH THE PRELIMINARY PLAT INCLUDING: (A) STREET NAMES. (NAMES OF NEW STREETS SHALL NOT DUPLICATE EXISTING OR PLATTED STREET NAMES UNLESS THE NEW STREET IS A CONTINUATION OF EXISTING OR PLATTED STREET). ALL DIMENSIONS, BOTH LINEAR AND ANGULAR, FOR LOCATING LOTS, STREETS, ALLEYS, PUBLIC EASEMENTS AND PRIVATE EASEMENTS. THE LINEAR DIMENSIONS SHALL BE EXPRESSED IN FEET AND HUNDREDTHS OF A FOOT, AND ALL ANGULAR MEASUREMENTS SHALL BE EXPRESSED BY BEARINGS OR ANGLES. ALL CURVES SHALL BE DEFINED BY THEIR RADIUS, CENTRAL ANGLE, TANGENT DISTANCES, TANGENT BEARING AND ARC LENGTHS. SUCH CURVE DATA SHALL BE EXPRESSED BY A CURVE TABLE LETTERED ON THE FACE OF THE PLAT, EACH CURVE BEING TABULATED AND NUMBERED TO CORRESPOND WITH THE RESPECTIVE NUMBERED CURVES SHOWN THROUGHOUT THE PLAT. (5) LOTS NUMBERED IN NUMERICAL ORDER; AND BLOCK IDENTIFICATION. (6) LOCATION OF ALL MINIMUM BUILDING SETBACK LINES. (7) THE LOCATION AND MATERIAL OF ALL PERMANENT REFERENCE MONUMENTS. (8) ALL PARCELS OF LAND INTENDED TO BE DEDICATED OR RESERVED FOR PUBLIC USE, OR FOR THE COMMON USE OF PROPERTY OWNERS WITHIN THE SUBDIVISION. (9) A DEFINITE BEARING AND DISTANCE TIE SHALL BE SHOWN BETWEEN NOT LESS THAN TWO PERMANENT MONUMENTS ON THE EXTERIOR BOUNDARY OF THE SUBDIVISION; AND TO EXISTING STREET INTERSECTIONS WHERE POSSIBLE AND REASONABLY CONVENIENT. (10) DATE AND NORTH POINT. (11) PRIVATE RESTRICTIONS AND THEIR PERIOD OF EXISTENCE. SHOULD THESE RESTRICTIONS BE OF SUCH LENGTH AS TO MAKE THEIR LETTERING ON THE PLAT IMPRACTICABLE AND THUS NECESSITATE THE PREPARATION OF A SEPARATE INSTRUMENT, REFERENCE SHALL BE MADE THERETO ON THE PLAT. (12) SIGNATURE PANELS FOR: CHAIRMAN AND SECRETARY OF THE CITY PLANNING COMMISSION FOR LAND LYING WITHIN THE CORPORATE LIMITS; FOR LAND LYING OUTSIDE THE CORPORATE LIMITS THE SIGNATURE PANEL